Power switch doesn't catch on the board - Printable Version +- Freeplaytech Forum (https://forum.freeplaytech.com) +-- Forum: Freeplay Zero / Freeplay CM3 / Game Pie Advance (https://forum.freeplaytech.com/forumdisplay.php?fid=24) +--- Forum: Freeplay Zero/CM3 (AKA GPA) Hardware (https://forum.freeplaytech.com/forumdisplay.php?fid=25) +--- Thread: Power switch doesn't catch on the board (/showthread.php?tid=4540) |
Power switch doesn't catch on the board - deliveryninja - 01-26-2018 I cannot seem to get the power switch to work as the black switch on the cm3 board sits too low and the switch jist moves over it. Any ideas on a fix? Thanks. RE: Power switch doesn't catch on the board - Flavor - 01-26-2018 The first thing to do is make sure that your shell is closing fully. Maybe there is something keeping it from coming together all the way. RE: Power switch doesn't catch on the board - deliveryninja - 01-27-2018 I have tried to remove some foam from behind the screen to see if it was holding the board too high but I am not sure it is possible to get it to catch without putting pressure on top of the power connectors. I screwed the circuit board in and took some pictures to show how it cannot currently go any lower than it is. https://imgur.com/a/lxuLa I think I'll find a way to rectify it, I was thinking a small wire to bind them together rather than glue or somehow extending the prong up. Alternatively I could put pressure on the power connector from the back of the case. RE: Power switch doesn't catch on the board - Flavor - 01-27-2018 In the bottom right of that photo, there’s a screw in the circuit board. That shouldn’t be there. I bet it’s holding the shell from coming together fully. RE: Power switch doesn't catch on the board - deliveryninja - 01-27-2018 Okay when I put it together, I placed a small piece of cardboard under the switch and it's raised it enough that it seems to work no problem. The bottom right screw is just there to see how close I can get the board to the shell, I have been putting that in from the outside of the shell when testing. Thanks for the help, I think it's all in place time for the final build! RE: Power switch doesn't catch on the board - Flavor - 01-27-2018 Oh, okay. I'm glad you got it working. Sorry for jumping to the wrong conclusion there. RE: Power switch doesn't catch on the board - deliveryninja - 01-27-2018 No worries appreciate the quick replies, can't wait to get it up and running now |