![]() |
Changing input issue - Printable Version +- Freeplaytech Forum (https://forum.freeplaytech.com) +-- Forum: Freeplay Zero / Freeplay CM3 / Game Pie Advance (https://forum.freeplaytech.com/forumdisplay.php?fid=24) +--- Forum: Freeplay Zero/CM3 (AKA GPA) Software (https://forum.freeplaytech.com/forumdisplay.php?fid=26) +--- Thread: Changing input issue (/showthread.php?tid=5177) |
Changing input issue - zedd - 11-17-2020 Good day! Having an issue I couldn't find written about elsewhere. I try to Configure Inputs with the built in buttons, to reconfigure where the system believes A, B, X and Y are, and it accepts everything fine until I get after the left and right triggers. In the past, I would hold a button, and it would "skip" the inputs, and let me continue through until I got to setting up the hot key, and then everything would be mapped. At this time, it will not let me skip. I tried mapping a keyboard, and it was more than fine with letting me skip inputs on it. Any ideas? ![]() RE: Changing input issue - Porcinus - 11-17-2020 Hi, Are you talking about Emulation Station? I don't have my handheld on hand but if I remember it right, once you have set A and B, you can hold B button for a few seconds to skip current input definition. RE: Changing input issue - zedd - 11-17-2020 (11-17-2020, 03:33 PM)Porcinus Wrote: Hi, Thanks for your reply! Yes, I am using Freeplay Tech CM3; in the past, I was able to hold any button to skip the input, but now, no buttons will let me skip. I had just reimaged my SD card due to a screw up I had with an NES emulator, so it is a fresh image. Otherwise, it is all the same unit; buttons all work, just no skipping inputs. RE: Changing input issue - Porcinus - 11-19-2020 Sorry, I didn't received any reply notification. Sadly, it is the only way I am aware about :/ Hopefully, someone will be able to help you. |