White line on screen and joystick code (cm3)

[Flavor]

For configuration, you should have a file called /etc/modprobe.d/mk_arcade_joystick.conf on your system. If you can ssh in or use a keyboard, then run something like this to edit it.

sudo nano /etc/modprobe.d/mk_arcade_joystick.conf

There will be a bunch of lines that start with a #. Those are NOT in use. There should be only ONE line without a #. That's the one in use.

You can edit that line, or you can put a # in front of it and remove a # from another line.

OR you can just look over the lines to get an idea of the format.

The tricky part is knowing the address and params needed for your analog setup. The bottom of this document explains that a bit.
https://docs.google.com/document/d/1GkmF...m7lz97h0mc


You can also try this tool to automate the process.

cd /home/pi/Freeplay/mk_arcade_joystick_rpi
make config

That will try to build the config stuff and install it using an interactive tool to detect the proper settings.