06-24-2018, 02:54 AM
I recently put my CM3 build together and have been unable to get past that infamous white screen issue. I'll hold down the switch (for around 5 seconds) till I get the green light but the white screen never changes. When I attempt to shut down by holding the switch again there is no change on the screen no matter how long the switch is held. I can only power down by removing the power source. I've got through just about all of the troubleshooting tips including:
-Using an older image
-Multiple different programs to flash the image
-2 different micro SD cards
-Using only battery power, using only micro USB power
-Double (and triple) checked the ribbon cable is seated, as well as the CM3
When I connect to a monitor using the HDMI output I get an error [1.4405131 ---[end Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block (179,2)]
https://imgur.com/SNUNeyG
This is my first time using a raspberry pi and it's got me stuck at this point.
-Using an older image
-Multiple different programs to flash the image
-2 different micro SD cards
-Using only battery power, using only micro USB power
-Double (and triple) checked the ribbon cable is seated, as well as the CM3
When I connect to a monitor using the HDMI output I get an error [1.4405131 ---[end Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block (179,2)]
https://imgur.com/SNUNeyG
This is my first time using a raspberry pi and it's got me stuck at this point.