01-14-2019, 01:41 AM
2) It seems that the L/R button "caps" often need to be shaved down. I think there are some photos of this in the build document. This is one of the biggest areas where combinations of aftermarket buttons/shells/etc seem to make the necessary cuts a bit on the random side.
3) Sometimes just spinning the button cap will alleviate problems here. If the post is at an angle, it can cause it to not click. Did you glue the cap to the button shaft? If so, if it's not perfectly centered, that's when spinning it can make a difference. I'm not sure if this is clear or not.
3) Sometimes just spinning the button cap will alleviate problems here. If the post is at an angle, it can cause it to not click. Did you glue the cap to the button shaft? If so, if it's not perfectly centered, that's when spinning it can make a difference. I'm not sure if this is clear or not.
Card Fighters' Clash 2 English Translation ( http://cfc2english.blogspot.com/ )
Neo Geo Pocket Flash Cart and Linker Project ( http://www.flashmasta.com/ )
Avatar art thanks to Trev-Mun ( http://trevmun.deviantart.com/ )
Neo Geo Pocket Flash Cart and Linker Project ( http://www.flashmasta.com/ )
Avatar art thanks to Trev-Mun ( http://trevmun.deviantart.com/ )